-40%

GEMS Sensors 165075, Sensor, Flow, 1.5-20GPM, 316SS, 1/2" NPT Female, 4.5-24VDC

$ 52.8

Availability: 100 in stock
  • Condition: New – Open box
  • Brand: GEMS SENSORS
  • All returns accepted: ReturnsNotAccepted
  • MPN: 165075
  • Port Diameter: 1/2 in

    Description

    GEMS Sensors 165075, Sensor, Flow, 1.5-20GPM, 316SS, 1/2" NPT Female, 4.5-24VDC. Shipped with USPS First Class.
    Description
    GEMS Sensors 165075 - RFO Series - Flow Rate Monitoring, Stainless Steel, 1/2 NPT Female Accurate Flow Rate Indication with Integral Visual Confirmation 4.5 to 24 VDC Pulsed OutputGEMS Sensors popularized the RotorFlow's paddlewheel design by combining high visibility rotors with solid-state electronics that are packaged into compact, panel mounting housings. They provide accurate flow rate output with integral visual confirmation...all with an unprecedented price/performance ratio. RFO Types feature a VDC pulsed output.Typical Applications Water Purification/Dispensing Systems Chemical Metering Equipment Lasers and Welders Water Injection Systems Semiconductor Processing Equipment Chillers and Heat ExchangersEasy Installation and MaintenanceA proper installation will enhance RotorFlow sensor performance. Install using standard pipe fitting tools; horizontal fluid lines are recommended. For further installation and maintenance recommendations, refer to one of the following instruction bulletins: RFO Types-Part Number 157258; RFI Types-Part Number 157259; RFS Types-Part Number 157261.Since their function is to monitor dynamic fluid flow, naturally the rotor will react to turbulence, pulsation, entrained air, and other flow anomalies induced in the flow stream by other process hardware. For optimum performance, install RotorFlow units where nominal flow conditions exist with ports located at the top. Incoming flow may be placed to either port; a minimum of 8 inches (20 cm) of straight pipe on the inlet side is required. When operating in the low flow range, the supplied Low Flow Adapter must be installed in the incoming port.Except for straight-thread versions, RotorFlow sensors connect to piping via NPT mating thread forms.. The use of an appropriate thread sealant is necessary to assure a leak-tight connection. Permatex 'No More Leaks ' or 2 wraps of Teflon tape are the only sealants