BACHMANN G SCALE 4-6-0 AND 2-8-0 REPLACEMENT or UPGRADE CAN MOTOR

Description

Hi This sale is for a replacement or upgrade of the Bachmann motor used in the G scale 4-6-0 and 2-8-0 locomotives. This motor is a drop in replacement or upgrade for the factory Bachmann motor in the G scale 4-6-0 and 2-8-0. No modifications to the motor mount in the locomotive are necessary. This motor will bolt in place of the original motor, it is the same size as the Bachmann motor. The only part needed for this conversion is the worm gear from the original motor. A worm gear
IS NOT
supplied with the motor. This motor may work in other Bachmann locomotives, Bachmann uses this size of motor in several of their G scale locomotives. Check the size of your motor to see if it matches the dimensions listed below. This motor
WILL
NOT
fit the Bachmann Shay, Climax, or Heisler.
This is a very high torque single shaft round can motor, it is designed for cordless drill service. The motor has a 5 pole armature, carbon brushes and brass bearings. The motor is 38mm long and 28mm in diameter, the motor shaft is 13mm long and 2.3mm in diameter. There are 2 mounting holes on the front of the motor tapped for 2.6mm screws, there are 2 solder terminals on the rear for electrical connections. Both motor terminals are isolated from the case of the motor. At 12 volts DC with no load, this motor draws 170ma and develops 9300 rpm, the stall current is 2.7 amps. This motor draws less current than the factory Bachmann motor. If you are running your locomotive on batteries, you may get a longer run time with this motor. This motor is
DCC
compatible with a high current decoder.
This motor will be shipped via USPS First Class Mail.  Note to international buyers: eBay determines the rates for international shipping. I have no control over what eBay charges for international shipping.
Thanks for looking.